Hypercardioid capsule head, capsule woodbox, nickel. Compatible with KM A (analog) or KM D (digital) output stages. Nickel finish
The KK 185 is a pressure gradient transducer with a hypercardioid characteristic. Attenuation of sound incidence from the side or rear is approximately 10 dB. Minimum sensitivity occurs at an angle of about 120.
Caractéristiques
Nickel
Supercardioid Polar Pattern
User installable
Non-reflective finish
Spécifications
Acoustical operating principle: Pressure gradient transducer Directional Pattern: Hypercardioid Frequency Range: 20 Hz...20 kHz Sensitivity at 1 kHz, 0 dB gain, and 94 db SPL: -42 dB FS Equivalent noise level, CCIR¹: 25 dB Equivalent noise level, A-weighted²: 16 dB-A Maximum SPL at 0 dBFS (re. 94 dB SPL): 136 dB SPL Maximum SPL with 18 dB preatt. (RCS) (re. 94 dB SPL): 154 dB SPL Signal-to-noise ratio, CCIR (re. 94 dB SPL)³: 69 dB Signal-to-noise ratio, A-weighted (re. 94 dB SPL): 79 dB Matching connector: XLR 3 F Weight (output stage): 70 g Weight (capsule only): 19 g Diameter: 22 mm Length (capsule only): 18 mm Length (microphone): 108 mm A/D conversion: Neumann process (patented), 28-bit internal word length Digital signal processing: Fixed-point, variable internal word length 28 bits to 60 bits Sampling rates: 44.1/48/88.2/96/176.4/192 kHz Output data format: 24 bits as per AES/EBU (AES 3) Latency: 44.1/48 kHz: 41 samples Latency: 88.2/96 kHz: 49 samples Latency: 176.4/192 kHz: 99 samples Synchronization: Free-running (non-synchronous operation), frequency stability: ± 25 ppm Synchronization: Synchronous operation, pulling range: min. ± 100 ppm Supply voltage range: +7 V to +10.5 V Current consumption: max. 150 mA (DDP)
¹ according to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
² according to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
³ according to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS according to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
