The M2T half-rack IEM/IFB transmitter houses two stereo transmitters to provide two stereo audio channels, and for up to four mono audio channels in a single rack space
The audio inputs can be individually configured to be analog or Dante compatible. The analog input connectors are full-size XLR/TRS combo types for balanced line-level analog signals while the input preamp circuits use a special balanced amplifier with very high common mode rejection to minimize hum and noise. A Dante Ultimo interface via dual RJ45 connectors accepts Dante networked audio inputs and can cascade the digital stream to additional units via CAT6 cables. An additional RJ45 jack provides an Ethernet connection for programming and control via Wireless Designer software and a USB jack on the front panel allows for firmware updates. The transmitter features a full color, backlit LCD for high visibility in any environment, while the chassis is all-metal and can be racked singly or in pairs using included rack mount hardware.
Caractéristiques
IEM (Wireless Monitor) with digital RF transmission
24-bit digital audio
2 independent stereo audio transmissions per 1/2 RV enclosure
USB port for firmware updates
Fully Dante compatible
IR (infrared) port for fast setup
Up to 50 mW per Rf carrier
All metal housing
Compatible with Wireless Designer Software
Spécifications
RF Power Output
Two carriers; two audio channels each
Power adjustable on each carrier to 10, 25 or 50 mW
Antenna Output: 2 x BNC sockets Operating Frequencies: 470.100 - 607.975 MHz Frequency Selection Steps: 25 kHz Frequency Stability: ± 0.002% Modulation: 8 PSK Emission Designator: 200KG7E Spurious Radiation: Compliant with ETSI EN 300 422-1 Equivalent input Noise: -128 dBV