This mic is part of the flexible d:dicate Microphones Series. It has a highly-directional supercardioid pickup pattern with a smooth and uniform off-axis frequency response.
The d:dicate 4018A Supercardioid Microphone is designed for a broad range of music recording and broadcast/ENG/film long-distance miking applications. It can be used for booming, dialogue, interview and table or spot-recording use. The mic also offers superb expandability through modular accessories. It is ideal for use as spot or hanging mic for orchestra recording situations.
The microphone capsule
The supercardioid shape is frequency independent, securing an identical sound color around the microphone. The usual rear lobe heard on most supercardioids is minimized on this capsule. This makes it much more isolated without sudden frequency dependent peaks and dips. A truly flexible range
This mic is part of the flexible d:dicate? Microphone Series. At any time, and with no tools needed, it is possible to transform the d:dicate? 4018A Supercardioid Microphone into a new configuration. You can combine it with another d:dicate? or d:facto? Microphone Capsule or Preamplifier.
Caractéristiques
Low noise and high sensitivity
Highly directional for high isolation
Most controlled supercardioid shape
Uniform, frequency independent directionality
Excellent for spot miking orchestra sections or singers
Modular flexibility
Spécifications
Directional pattern: Supercardioid Principle of operation: Pressure gradient Cartridge type: Pre-polarized condenser Frequency range: 20 Hz - 20 kHz Frequency range, ± 2 dB, at 30 cm: 40 Hz - 18 kHz Sensitivity, nominal, ± 2 dB at 1 kHz: 12 mV/Pa; -38.4 dB re. 1 V/Pa Equivalent noise level, A-weighted: Typ. 16 dB(A) re. 20 µPa (max. 19 dB) Equivalent noise level, ITU-R BS.468-4: - S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 78 dB(A) Total Harmonic Distortion (THD): < 1 % up to 137 dB SPL peak Dynamic range: Typ. 121 dB Max. SPL, peak before clipping: 157 dB Switchable attenuator, filters etc.: 0 dB / -20 dB Output impedance: 200 Ohms Minimum load impedance: 2 k Cable drive capability: 100 m (328 ft) Output balance principle: Impedance balancing with Active Drive Common Mode Rejection Ratio (CMRR): > 60 dB Power supply (for full specifications): 48 V Phantom power (±4 V) Current consumption: 2.8 mA
Connector: XLR-3M
Pin 1: shield
Pin 2: signal + phase
Pin 3: - phase
Color: Matte black Weight: 158 g (5.6 oz) Microphone diameter: 19 mm (0.75 in) Capsule diameter: 19 mm (0.75 in) Microphone length: 170 mm (6.7 in) Output voltage, RMS: 7 V Polarity: +V at pin 2 for positive sound pressure Temperature range: -40 C to 45 C (-40 F to 113 F) Relative Humidity (RH): Up to 90% Matching tolerance: ± 1 dB Phase deviation for kit: < 10
