Encore Two-Channel One-Amp, (Two-Amp Peak), 1RU Rack Mount, Universal Power Supply. One A/B Selectable Jack And One Program Input
The PS-702 can deliver 1.2 amps at 30 volts DC to two channels. This is sufficient to power up to 40 beltpacks, 10 speaker stations, or 12 headset stations even under the most demanding conditions. Either channel is capable of supplying up to 1.2 amps. The full current capacity may be divided between the two channels.
Caractéristiques
Provides up to 2 amps at 30 Volts
Supports up to 40 beltpacks, 10 speaker stations, or 12 headset stations
Full current capacity can be divided between the two channels
Exclusive Intelligent Fault/Overload Sensing (IFOS) for system reset
A+B Link switch for single-channel operation
Built-in test tone generator for set up and diagnostics
UL listed and CE certified
Line and load regulated
Short-circuit protected
Spécifications
Program Line Input
Maximum Level before Clipping: >= 20dBu
Input Impedance: >= 5K
Frequency Response
Program Input - Partyline: 200 - 20KHz ± 3dB
Max Distortion
Program Input - Partyline: <= 0.2%
Noise
Program Mic Input - Partyline:< -70dBu
Max Gain
Program Input - Partyline: >= -16dB
Min Gain
Program Input - Partyline: <= -20dB
Mains Power
Input Voltage Range: 100 - 240 VAC
Input Frequency Range: 50 - 60 Hz
Input Power: <= 60 VAC
Output Voltage: 30 VDC ± 0.5V
Output Current per Channel (Continuous): 1.2 A
Output Current per Channel (Peak): 2 A (Do not exceed the 1.2A rating for more than 2 seconds per 1 minute period)
Short Circuit Recovery Time (1st short): <= 0.5 sec
Short Circuit Recovery Time: >= 20 shorts in 20sec <= 20 sec
Station Capacity
Up to 40 RS-601 beltpacks or 10 speaker stations or 12 headset stations distributed over both channels
