The A10-RACK is a 1-RU enclosure which accepts slot-in wireless receivers such as the Audio Limited A10-RX or other brand receivers.
The A10-RACK features built-in power and antenna distribution plus Dante for up to 4 two-channel slot-in receivers. That is a total of eight channels of Dante, plus AES digital outputs, or analog outputs- all in a single, sleek, 1-RU chassis. The A10-RACK accommodates single-channel Unislot receivers and most two-channel Superslot-compatible receivers, such as Audio Limited's A10-RX or other models from Lectrosonics and Wisycom utilizing the D-sub 25 pin interface.
Dante
The Digital Audio Network Through Ethernet protocol, better known as Dante?, allows for true networking where signal can be sent to many destinations without degradation or extra hardware. Connect the A10-RACK to a Dante network, and all eight channels of high-quality audio from the wireless receivers can be transported over a single Cat5 network cable. Monitoring and routing of signals from transmitters to receivers is simplified with the Dante Controller, a free software application from Audinate.
RF Inputs
The A10-RACK also sports RF inputs with 12V powering of active antennas, plus loop-thru connections for another A10-RACK. This provides seamless integration between two connected A10-RACKs with a single pair of antennas - resulting in reduced complexity for 16-channel configurations and additional cost savings.
Power Options
The A10-RACK is powered with a standard 4-pin F-XLR 10-18v DC power supply, like the Sound Devices XL-WP4 (shown right). This power supply should be capable of providing 3A minimum for proper powering of the A10-RACK and the slot receivers.
Caractéristiques
4-slot wireless receiver rack system
(receivers sold separately)
8-ch Dante / AES / analogue outs
Receiver diversity (Unislot / SuperSlot?)
Built-in power and antenna distribution
Antenna loop-thru for 16-channel setups
4-pin DC XLR input
USB serial port for firmware updates
Spécifications
Frequency range: 470-694 MHz
Number of diversity receivers: Up to 4
Active distribution amplifier bandwidth: 224MHz, with phantom powering for active antennas - 12V, 200mA
Antenna inputs: 2 x BNC 50 Ohms
Aux RF outputs: 2 x BNC 50 Ohms
Rack powering: 10 - 18 Volts DC, 3Amps via 4 pin XLR male socket
Audio outputs: 8 x 3 pin XLR-M analogue and or AES
Other Audio outputs: 2 x RJ45 to provide Dante? primary and secondary